Study on preparation of limitting current type oxygen sensor by tape casting and co-fired technique

YAO Wei; LIU Xi; ZHOU Ming-jun; WU Qiang

doi:10.13873/j.1000-97872012.08.028

Chinese

您当前的位置：

首页 >

文章列表页 >

Study on preparation of limitting current type oxygen sensor by tape casting and co-fired technique

更新时间：2025-09-11

- Study on preparation of limitting current type oxygen sensor by tape casting and co-fired technique
- Vol. 31, Issue 8, Pages: 9-11+14(2012)
- 作者机构：
  
  中国电子科技集团公司第四十九研究所
- 作者简介：
- 基金信息：
- DOI：10.13873/j.1000-97872012.08.028
  CLC： TP212
- Published：2012
- 稿件说明：
移动端阅览
[1]姚伟,刘玺,周明军,武强.流延共烧结制备极限电流式氧传感器的研究[J].传感器与微系统,2012,31(08):9-11+14.

YAO Wei, LIU Xi, ZHOU Ming-jun, et al. Study on preparation of limitting current type oxygen sensor by tape casting and co-fired technique[J]. 2012, 31(8): 9-11+14.
[1]姚伟,刘玺,周明军,武强.流延共烧结制备极限电流式氧传感器的研究[J].传感器与微系统,2012,31(08):9-11+14. DOI： 10.13873/j.1000-97872012.08.028.

YAO Wei, LIU Xi, ZHOU Ming-jun, et al. Study on preparation of limitting current type oxygen sensor by tape casting and co-fired technique[J]. 2012, 31(8): 9-11+14. DOI： 10.13873/j.1000-97872012.08.028.

摘要

以流延成型工艺制备钇稳氧化锆（YSZ）基片

采用丝网印刷、等静压叠层工艺

经1450℃共烧结制备极限电流式氧传感器。采用XRD

SEM对其物理性能进行表征

并在650℃、氧体积分数为0%～90%范围内对该陶瓷器件的伏—安特性、响应时间等输出特性进行研究

实验结果表明:该传感器在其体积分数范围内具有良好的极限电流平台

响应时间小于9 s（氧体积分数从20%～75%）

准确度达到0.5%。

Abstract

Tape casting process is used to produce yttria stabilized zirconia（YSZ）substrates.The limiting current type oxygen sensor by screen printing

isostatic laminating and co-fired at 1450℃.The physical characteristics are investigated by X-ray diffractometer and scanning electron microscope.The response time and V-I characteristics of oxygen sensor are tested at 650℃ with the oxygen volume fraction range 0%～90%.The result shows that this sensor has good limitting current platforms in the above range of the oxygen.The response time is less than 9s（the oxygen volume fraction range 20%～75%）and the accuracy can reach 0.5%.

关键词

Keywords

references

YSZ-based electrochemical sensors: From materials preparation to testing in the exhausts of an engine bench test [J] . Elisabetta Di Bartolomeo,Maria Luisa Grilli. Journal of the European Ceramic Society . 2005 (12)

Aqueous tape casting of silicon nitride [J] . Bernd Bitterlich,Jürgen G Heinrich. Journal of the European Ceramic Society . 2002 (13)

Oxygen sensing characteristics of limiting current-type sensors with microstructural and structural variations in diffusion barrier [J] . Jong-Heun Lee,Hoin Kim,Byung Ki Kim. Materials Letters . 1996 (1)

Views

171

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on technology of water-based tape casting for limiting current oxygen sensor

Study on preparation technology of porous protective coating slurry for oxygen sensor

Research on diffused hole of limiting current oxygen sensor fabricated by screen printing method

Thermo dynamic analysis and structural optimization on limiting current oxygen sensor

Experimental study on temperature characteristics of oxygen sensor on motorcycles with EFI system

Related Author

SHAO Zhiqiang

PI Qianqian

WEN Jiyan

LIU Zhiyuan

WANG Liang

LIU Yang

LIU Zhiyuan

YU Haichao

Related Institution

China Electronics Technology Group Corporation

College of Information and Communication Engineering,Harbin Engineering University

Ningbo University of Technology

School of Information Science and Engineering,Ningbo University

School of Mechanical and Electrical Engineering,Harbin Engineering University

⁰