Effect of protective layer on response characteristics of automobile exhaust gas oxgen sensor

XIA Chao-yang; LU Xu-chen; YAN Yan; WANG Ti-zhuang; ZHANG Zhi-min; YANG Su-ping

doi:10.13873/j.1000-97872011.08.036

Chinese

您当前的位置：

首页 >

文章列表页 >

Effect of protective layer on response characteristics of automobile exhaust gas oxgen sensor

更新时间：2025-09-11

- Effect of protective layer on response characteristics of automobile exhaust gas oxgen sensor
- Vol. 30, Issue 8, Pages: 25-27+30(2011)
- 作者机构：
  
  中国科学院过程工程研究所多相复杂系统国家重点实验室
- 作者简介：
- 基金信息：
- DOI：10.13873/j.1000-97872011.08.036
  CLC： TP212
- Published：2011
- 稿件说明：
移动端阅览
[1]夏朝阳,卢旭晨,闫岩,王体壮,张志敏,杨素萍.保护层对汽车尾气氧传感器响应特性影响[J].传感器与微系统,2011,30(08):25-27+30.

XIA Chao-yang, LU Xu-chen, YAN Yan, et al. Effect of protective layer on response characteristics of automobile exhaust gas oxgen sensor[J]. 2011, 30(8): 25-27+30.
[1]夏朝阳,卢旭晨,闫岩,王体壮,张志敏,杨素萍.保护层对汽车尾气氧传感器响应特性影响[J].传感器与微系统,2011,30(08):25-27+30. DOI： 10.13873/j.1000-97872011.08.036.

XIA Chao-yang, LU Xu-chen, YAN Yan, et al. Effect of protective layer on response characteristics of automobile exhaust gas oxgen sensor[J]. 2011, 30(8): 25-27+30. DOI： 10.13873/j.1000-97872011.08.036.

摘要

汽车尾气净化用电势型氧传感器的电极表面通常涂覆有一层保护层

以"过滤"废气中的杂质。考察了保护层制作工艺和保护层物理参数对电势型氧传感器稳态输出电压、使用寿命和响应时间的影响

结果表明:1)当制备保护层所使用的材料（主要是高温粘结剂）和传感器电极或电解质发生化学反应时

测量得到的稳态输出电压也会和真实值相差甚远。选定质量分数为20%硅胶作为高温粘结剂可制备得到性能优良的传感器保护层;2)在保护层制备过程中加入适当比例的YSZ粉末材料

可使电极保护层的使用寿命提高;3)传感器的总响应时间与传感器保护层的物理性能（厚度、孔径等）和传感器的工作温度密切相关。

Abstract

A protective layer coating on the electrode of potentiometric oxygen sensor in automobile is commonly used to clean exhaust gas.Influences of the preparation procedure and the material of the protective layer on output voltage

lifetime and response time of the potentiometric oxygen sensor have been thoroughly investigated.The experimental results show that there are huge differences between the measured values and the realistic values for the output voltage of the potentiometric oxygen sensor when the materials of 20 % mass fraction silica gel is used to fabricate the protective layer can react with sensor’s electrode material or electrolyte material.The lifetime of the protective layer can be enhanced by adding some YSZ powder into the protective layer.Response times of the potentiometric oxygen sensor are closely related to the physical parameters（thickness and pore size）of the protective layer and sensor’s working temperature.

关键词

Keywords

references

ZrO 2 氧传感器多孔保护层研究 [J]. 路顺,林健,张舜. 玻璃与搪瓷 . 2006(05)

交流阻抗谱测试技术在固体电解质氧传感器研究中的应用 [J]. 简家文,杨邦朝,张益康. 功能材料 . 2004(04)

ZrO 2 氧传感器电极保护层的模拟 [J]. 夏风,肖建中,罗志安,冯江涛. 传感技术学报 . 2004(02)

Characteristics of cathodic polarization at Pt/YSZ interface without the effect of electrode microstructure [J] . Sung Pil Yoon,Suk Woo Nam,Seung-Goo Kim,Seong-Ahn Hong,Sang-Hoon Hyun. Journal of Power Sources . 2003 (1)

Characterisation of composite SOFC cathodes using electrochemical impedance spectroscopy. Analysis of Pt/YSZ and LSM/YSZ electrodes [J] . A. Barbucci,R. Bozzo,G. Cerisola,P. Costamagna. Electrochimica Acta . 2002 (13)

Response rate techniques for zirconia-based Nernstian oxygen sensors [J] . S. P. S. Badwal,M. J. Bannister,F. T. Ciacchi,G. A. Hooshmand. Journal of Applied Electrochemistry . 1988 (4)

Hysteresis effects with ZrO 2 oxygen sensors exposed to non-equilibrium oxygen-hydrocarbon mixtures [J] . J. E. Anderson,Y. B. Graves. Journal of Applied Electrochemistry . 1983 (3)

Views

138

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Response time measurement method for infrared detectors based on amplitude-frequency characteristic decoupling

Research and design of water-outlet sensor based on photoelectric sensing technology

Preparation and study of high-temperature characteristic of platinum resistor thin-film temperature sensor

Preparation and study of porous CuBr NH₃ sensor with high sensitivity and fast response time

Physical simulation analysis of response time of Hall sensor

Related Author

LIANG Ting

LI Fengchao

LI Tengteng

LEI Cheng

LU Jin

ZHANG Zhenyu

MAO Ling

LIU Zengwu

Related Institution

National Key Laboratory of Extreme Environment Optoelectronic Dynamic Testing Technology and Instrument,North University of China

Dalian Scientific Test and Control Technology Institute

Key Laboratory of Instrumentation Science and Dynamic Measurement,Ministry of Education,North University of China

Key Laboratory of Micro/Nano Devices and Systems,Ministry of Education,North University of China,Taiyuan

The 49th Research Institute of China Electronics Technology Group Corporation

⁰