Failure analysis and improvement of sealing material crack of ZrO<sub>2</sub> oxygen sensor

LIU Zhi-min; QIN Hao; WANG Yang-yang; ZHOU Ming-jun; HAO Yu-fang

doi:10.13873/J.1000-9787(2018)04-0038-03

Chinese

您当前的位置：

首页 >

文章列表页 >

Failure analysis and improvement of sealing material crack of ZrO₂ oxygen sensor

更新时间：2025-09-11

- Failure analysis and improvement of sealing material crack of ZrO₂ oxygen sensor
- Issue 4, Pages: 38-40(2018)
- 作者机构：
  
  中国电子科技集团公司第四十九研究所
- 作者简介：
- 基金信息：
- DOI：10.13873/J.1000-9787(2018)04-0038-03
  CLC： TP212
- Published：2018
- 稿件说明：
移动端阅览
LIU Zhi-min, QIN Hao, WANG Yang-yang, et al. Failure analysis and improvement of sealing material crack of ZrO₂ oxygen sensor[J]. 2018, (4): 38-40.
DOI：

LIU Zhi-min, QIN Hao, WANG Yang-yang, et al. Failure analysis and improvement of sealing material crack of ZrO₂ oxygen sensor[J]. 2018, (4): 38-40. DOI： 10.13873/J.1000-9787(2018)04-0038-03.

摘要

针对氧化锆（ZrO

）氧传感器封接料失效机理

提出了在传感器加热电路上增加预热功能

通过仿真和试验的方法验证了改进措施的有效性。仿真分析的结果表明:温度变化幅度为200℃时应力状态较温度变化400℃时的应力降低幅度约为40%。通过试验样件验证表明

传感器在进行了576次启动热应力试验后

封接料状态良好

未开裂

表明加热电路增加预热功能后降低了热应力冲击强度

增加预热电路后

传感器有效避免了使用中出现封接料开裂故障。

Abstract

According to failure mechanism of sealing material of ZrO

oxygen sensor

preheating function is put forward to add in sensor heating circuit. The effectiveness of the improved measure is verified by simulation and experiment.The results of simulation analysis show that the stress is reduced about 40% from temperature change range 200 ℃ to 400 ℃.The sample test results show that

after 576 times starting thermal stress tests are carried out

the sealing material is in good condition

without cracks.The results show that heating circuit can reduce the thermal stress impact strength after adding preheating function

which can avoid sealing material cracking in sensor usage.

关键词

Keywords

references

Views

119

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Analysis of the effect of thermal vacuum test on the performance of limiting-current oxygen sensor

Influence of transition layer on performance of chip switch type oxygen sensor for automobile

Research on drift analysis and improvement of heating electrode of ZrO₂ oxygen sensor

Study of main failure modes and failure mechanisms of MEMS inertial devices

Dynamic measurement and computation of limiting current type oxygen sensor

Related Author

ZHANG Wei

LIU Zhimin

GE Jiangya

WANG Dongwei

WEI Hongyan

LIU Yang

LIU Xi

WEN Jiyan

Related Institution

The 49th Research Institute of China Electronics Technology Group Corporation

China Astronaut Research and Training Center

Science and Technology on Reliability Physics and Application of Electronic Component Laboratory,The Fifth Electronic Research Institute of the Ministry of Industry and Information Technology

Faculty of Automation,Guangdong University of Technology

School of Electrical and Information,South China University of Technology

⁰

Failure analysis and improvement of sealing material crack of ZrO2 oxygen sensor

DOI：10.13873/J.1000-9787(2018)04-0038-03

摘要

Abstract

关键词

Keywords

references

Failure analysis and improvement of sealing material crack of ZrO₂ oxygen sensor