SHANG Xiao-yan, LI Bing, HE Yi-gang, et al. Design of IED for condition monitoring based on RFID technology[J]. 2016, 35(6): 93-95+103. DOI: 10.13873/J.1000-9787(2016)06-0093-03.
主要由微处理器、温度传感器、电流传感器、电压传感器和一种有源RFID芯片构成。仿真与测试结果表明:IED天线回波损耗约为-13.1 d B
载波频率为865.8 MHz时
IED最大读写距离为18 m
IED驱动电流和工作电流分别为520
210μA
性能优于SL9000A。
Abstract
Aiming at problem that the existing transmission and distribution equipment on-line monitoring system is not satisfied with accurate malfunction locating and intensive monitoring of multi-parameter
present a new type of transmission and distribution equipment on-line monitoring system architecture and focus on intelligent electronic device( IED) for condition monitoring. Design a IED for condition monitoring that is based on RFID
the IED mainly consists of MCU
temperature sensor
current sensor
voltage sensor
and a battery-assisted RFID chip.Results of simulation and test show that
return loss of antenna of IED is about- 13. 1 d B
the maximum reading and writing range of IED is 18 m when the carrier frequency is 865. 8 MHz
drive current and working current of IED is 520 μA and 210 μA